If you have a framebuffer already due to an attached monitor, it will duplicate it, using the same graphic resolution as that monitor. If you have no monitor connected at boot up, it will not create a framebuffer, so no GUI applications will run. PI4 + Raspbian Buster graphics work differently to previous generations. I have setup already, TeamViewer, SFTP, NextCloud, VNC, Deluge, Webserver.i don't want to setup all again. when i disconnect it, the GUI will not start anymore.Ĭan you pelase Help me solve this problem, i don't want to reinstall the whole Pi again. but same errors.Īgain, when i connect the monitor, evendough the monitor is not started, it's just in standby, the GUI starts / works withouth problems and I can connect to TeamViewer and VNC. installed another startx (sudo apt-get install xserver-xorg-legacy).which i can start only with "sudo startx". I have tryed to use the command "startx" it just gives me somme arched the internet for solutions. Then i shut down the Raspberry, disconnect the monitor, start the Raspberry, and i cannot connect anymore to TeamViewer, to VNC is possible to connect, but i don't see any GUI, i just see a black screen with a text "Cannot currently show the desktop".įrom the command line i have configured "raspi-config" to boot into GUI with login. When i connect a monitor, everything is ok, the GUI starts.and i can connect to TeamViewer and VNC. My problem: i have a Raspberry Pi 4 - 4Gb with Raspbian installed on it and when I start my Raspberry without a monitor connected to it, it will not start the GUI.
0 kommentar(er)
